i think i broke a fuse.
 

Hi,

I bricked my ps3 with e3 flasher on 4.11 (stupid) and i had rlod/ylod so i reflashed my 4.11 backup but now i have no usb, no screen and no hdd working :(
But before that i tried to reflash my backup in flash fun i broke the solder point sbe so i asked how to still unbrick it without that point on a irc channel and they said i had to solder vcc v3.3 to nor_tristate but that didn't work and then he said he made a mistake, i had to solder nor_tristate to vss(gnd) and that worked, no ylod anymore! but after reflashing my backup and removing the wire on mobo, i had no screen, no hdd, no usb so i think a fuse is blown so could anyone help me finding that fuse?

mobo model: dyn-001
ps3 model: cech-2004b

Thank you,
Scotch_be1
:)
************* [ - Post Merged - ] *************
reserved............. :)

By blowing a fuse do you mean you "fried" it or could you possibly have pulled it off of the board entirely? Knowing this would be a good start to helping you go on from here. Will need to know what motherboard and what model ps3 you have and will also need to know generally where this fuse is (or was) located. Also, if you have a multimeter go ahead and check voltage of said fuse to make sure you "fried" it or not.

After you flashed your backup, there should be no video and no hdd activity. Then put the e3_downgrade.bin on the SD card with your backup. Put switch 1-5 down and 6 up, and follow the downgrade tutorial below from that point.

Also just leave the wire soldered until you are done, so you don't have to keep soldering it on and off to use flash fun mode. If you need to try it again.

already tried that but my ps3 isnt reading any usb so e3 card reader doesnt work :(

Please help :-(

Not sure. Maybe something was messed up by hooking the wire up to the wrong point. :dontknow: