Progskeet v1.2 dump verification failed
 

Hi.
I want to dump my ps3 with progskeet 1.2 and the 80-90% of verification is failed. Spansion P, R7-open, R8-soldered, awg26 wires 8-9cm. Powered on with ps3 PSU. Newest bitstrem and winskeet. I resoldered everything threetimes. What can be wrong?

Did you check for shorts ?

i have the progskeet v1.2 but i can't dump
i post my problem here http://www.ps3hax.net/showthread.php?t=47179


what is the R7 and R8 ON progskeet v1.2 ????

-Powered on with ps3 PSU
How can i do that ??

PLEASE HELP ME

Progskeet 1.2 canot check shorts, or you mean with multimeter?
I dont connected 3,3V from morherboard to progskeet, is that good?

amined:
R7 soldered - for NAND
R8 soldered - FOR NOR

No, check for shorts using winskeet.

And how about dump CFI ? DID YOU DUMPED YOUR CFI ?

Using multimeter check for continuity on the wires.

Progskeet 1.2 gives a lot of random shorts when checkin with winskeet, its a bug. I read here at forum that progskeet 1.2 canot dump CFI. Always gives a error mesage: CFI is invalid ( does not begin with "QRY" ).

thank's for reply


http://data.imagup.com/12/1168436768.jpg


i have NAND R7
what is this switch ?

Yes, its a bug, but you can fix it.

First install the libusb driver and then re-install the winusb driver back

Without DUMP CFI, you won't be able to write back.

Attachment 1957

R7 is soldered by factory default
************* [ - Post Merged - ] *************
Where can i find the libusb driver, can you give me a link please.