I'm a noob & i have bricked my ps3 while downgrading. plz help!
 

I bought the e3flasher and i followed the instructions in E3 FLASHER INSTALLATION and DOWNGRADE TUTORIAL (Khalkedon) - YouTube & some threads here and there but during the "restore" process i think i bricked the ps3. Now it will power for 2-3 seconds then switch off again. I also have e3-reader but i didn't use it yet.

I tried to search the forum for any similar thread to get an answer but it all involve soldering or involve inspecting the dumps so i thought i need to start one.

I also don't know how to enter to that special chat page for ps3 gurus and when i could, no one was there.

- I need to un-brick without soldering if it was possible. If it's necessary to sodler the linker then does someone has a youtube on how to do it because it will be my first time soldering. I can borrow the equipment from my friend.

- I also need someone to check my dump because i don't know how i can do that because I didn't even know how to interpret the data in the flower builder.

Sorry but i'm really frustrated and this is my first post in this forum though i'm a fan since a long time but been just reading.

Please help me i'm new to all this.

Remove the link to your dump and email it to dumpcheck @hotmail .co.uk

Are you saying you flashed your console without checking your dump???


Sent from my iPhone 5 using Tapatalk

I just removed it from here and sent the email. Is the email yours?

Regarding flashing, well, not the entire flashing process. Once i got the dumps, the guide in youtube said to "restore" first but i guess something wrong happened there, maybe i accedintally pressed on one of the swithces to be up instead of down or vice versa. And yeah, i really didn't know how to check my dump. I'm so sorry, i'm just another noob who wanna be the one who could downgrade on his own but i failed, and i regret it now deeply.

Thanks for your reply. :)

The email address is a collective of known goodies that check the dumps




Sent from my iPhone 5 using Tapatalk

Thanks again for your help. I'll wait for them to check it for me.

Not received it yet pal are you sure you sent it dumpcheck @hotmail .co.uk



Sent from my iPhone 5 using Tapatalk

@fsl
@Sarah1331
Will i checked his Dump it looks valid
but the " norpatch" did not recognize Ros1 other than that it is ok

So what is the next step now? how can i un-brick my ps3? do i really need to solder the e3 linker or there is another way which doesn't involve soldering? if i really have to, is there a youtube video to teach me how to do it?

You need to halt your Ps3 by soldering the TRi point to a ground point so it will not turned off

I can solder it to any ground point in the mother board? not a specific point?
************* [ - Post Merged - ] *************
Is the tri point in the mother board or in the e3 linker? any TUT available?