help me please
 

i need advice please, i was on Rogero CFW 4.30 v2.03 and then i went back to kmeaw with no problems, before i went to Rogero CFW 4.30 v2.03 i was on kmeaw with the 9.99 spoofer but i did not uninstall it, i just flashed rogero from xmb, now im back on kmeaw and i went to spoof again and all i get is black screen, i can get into recovery but it wont accept any cfw so i went to do a restore and again im at a black screen, is there a easy fix for this mess that i have made for myself?

Once you installed Rogero 2.03 your spoof on kmeaw will have been overwritten.

It cant be anything to do with what you previously had installed.

You should try the dehash/instal OFW 3.55 ideals and go from there.

@toolz try rebug 999 downgrader after that rebug 3.55.3 then go to whatever firmware

i tried it but all i get in recovery is install 3.55 or higher? i press start and select and get that error
forgot to mention that after i went back to kmeaw i installed 9.99 spoof, and it hanged for a few seconds then i waited a while while it did its thing but i waited a long time so i hard reset

Can you reinstall 3.55 OFW.

You should be able to.

X:/PS3/UPDATE/PS3UPDAT.PUP

Check this out for dejavu:

http://www.ps3hax.net/showpost.php?p...&postcount=156 <- 3 weeks ago

@toolz reread that old thread and see if you can figure it out from there?

i will try again now
same error no applicable update data

try the port closest to the bd drive, the 999 should work. Make sure there is no disc in the drive

tried it mate no luck

The only other ideas I have are Flash it or try FSM.
Unless the file structure or naming is wrong on the usb. PS3UPDAT not ps3updatE

I can only enter FSM i can not get into XMB due to black screen, no matter which ofw cfw i choose none will work i just get the error message saying no data