Originally Posted by jhax78
make the tut here too i don't like that site
and thx again for it
Team Kado has released a TB2 Downgrade Patch to bypass the SYSCOM checks and allows you to install the True Blue Custom Firmware on your downgraded PS3's, and therefore allowing you to use the True Blue dongle.
(Hardware is required to downgrade the PS3!)
How to use it:
If you intend to downgrade 3.56+ console and use TB dongle
1 - Dump your NOR flash using Progskeet first if you didn't have a good dump from your console.
2 - Download patch file attached to this thread.
3 - Extract this file and you will get 4 folders use patch in folder "Coba_2" to patch your dump using WinSkeet.
4 - Apply this patch to your dump then flash it to your console.
5 - Enter a Factory Service Mode using any method you like.
6 - Use TB CFW with Lv2diag.self to flash your TB CFW in FSM.
7 - Start your console normally, if it brick just dump this NOR flash again then patch again using "Coba_2" patch.
8 - If it still bricked use "Coba_3" patch to patch your dump again then flash it back to your console.
9 - Start console normally, now your console can run TB CFW on downgraded console.
10- Power off your console, plug your TB Dongle then power it on again and enjoy .
Download KADO True-Blue JB2 Patch for Downgraded consoles
thanks to Abkarino
from ps3crunch.net, for sharing the news with us.
The above is still unconfirmed at the moment -