PS3Hax Network - Playstation 3 Hacks and Mods - View Single Post

jocose · 03-28-2012

Hey everyone,

I am pretty sure I broke the nor clip that came with my e3flasher.

I have a DYN-001 board with a samsung flash.

The problem was that the clip would not sit flush with the chip because of a transistor that is very close to the pins on one side.

This transistor wedges itself between the clip and my board. I took an exacto knife and very carefully chipped some of the outer shell off the clip to see if I could get it to fit better, but it never really secured to the chip.

I kept getting the can't initialize PS3 bios error 10001100

So I have two questions:

Has anyone else done a similar install to this?
And, is there any way that I can still use my e3 flasher with a solder setup. I have a lot of soldering experience and all the equipment. Is there any diagrams that I could use to solder directly to the thing on a slim?

03-28-2012	#1
jocose Apprentice Join Date: Mar 2012 Posts: 25 Likes: 0 Liked 0 Times in 0 Posts Mentioned: 0 Post(s) Tagged: 0 Thread(s)	e3 flasher questions: can I solder? Hey everyone, I am pretty sure I broke the nor clip that came with my e3flasher. I have a DYN-001 board with a samsung flash. The problem was that the clip would not sit flush with the chip because of a transistor that is very close to the pins on one side. This transistor wedges itself between the clip and my board. I took an exacto knife and very carefully chipped some of the outer shell off the clip to see if I could get it to fit better, but it never really secured to the chip. I kept getting the can't initialize PS3 bios error 10001100 So I have two questions: Has anyone else done a similar install to this? And, is there any way that I can still use my e3 flasher with a solder setup. I have a lot of soldering experience and all the equipment. Is there any diagrams that I could use to solder directly to the thing on a slim?