View Single Post
Old 04-15-2012   #8
haz367
Senior Member
 
Join Date: Dec 2010
Posts: 2,038
Likes: 1,041
Liked 583 Times in 473 Posts
Mentioned: 237 Post(s)
Tagged: 0 Thread(s)
Thumbs up

i would but can't, this one is already finished and put back together, i made the pics while removing the e3 for another.. to many times removing power supply aint good either, i'm sorry..anyway u can do it!

just be sure the clip is fitted 100%, use transparant tape it sticks real good!
to make the e3 fit, some say cutoff a little, maibe..best way in my view is using a small (in dutch) vijltje(check image), sry don't know the english word
but sandpaper 1500 or so should work fine to

also check youtube and e3tech's "howto attach clip" avi etc..

take a deep breath and take your time, cutting the motherboard plate is maibe not required if u not leave it in after downgrade, otherwise i would cut the case a bit, watch it where the plate is in the way, mark it with a stift and cut it out, sand it to make smooth, clean it with a cain of air and now put that sucker on the NOR


please stop quoting full post's man

goodluck

Last edited by haz367; 04-17-2012 at 06:06 PM.
haz367 is offline   Reply With Quote