Originally Posted by Nuuleh
Hi I'm just wanting to Clear up somthing im a little confused about. My model is a CECHG wich is a NAND flash, now theres somthing about a clip that comes with the E3 chip for somthing about NOR only. So is the E3 still compatible or do i have to wait or somthing? Thanks!
|
Your best bet would be to go with Progskeet.
The info for the e3 linker on e3's site says it will do nand flash with soldering. But I think it is a misprint and means you can use the linker to solder and use with nor.
I was going to try and figure out how to use my e3 linker with a nand model, but I can not find any info on it. I did have one user say he downgraded his nand model with the e3 linker, but I think he was bullsh!tting. As I have found no proof of it possible.
I am going to order this
Progskeet solderless bundle, to downgrade nand models. Will also need an
injectus jtag programmer, to program the Progskeet for use with the solderless clips.