Bah, I give up! I think I ended up wrecking my clip, I can't even get it to stay on now. I think I'm going to try soldering on the e3 linker, since I don't have anything else to loose. I found a
picture with the points marked, my question, there's a ton of ground points marked, do I need to connect all of them to my e3 linker and if I do, does it matter which one goes where?
Another question... my current soldering iron doesn't have a fine enough tip for this job, can someone recommend something fairly inexpensive that will get the job done? I'll also need
wire and
solder, will these work (following suggestions from the dev wiki.)