Originally Posted by playerkp420
Well, I soldered the wires from the solderless adaptor to the Progskeet. I still couldn't dump the nand.
So I tried the other nand and used a spring clamp to hold the clip on. It worked great. Winskeet recognized what brand chip and I dumped it.
But when I try the other nand, winskeet only recognizes it when I hold the clip down and twist it a little. I can't get the spring clamp on as good as I could the othe chip.
So it is definitely the contact of the 360 clip. Maybe I just need to solder all these wires, instead of messy with this crappy clip.
|
yea like i said the clips are supposed to be faulty from the start.
did you scrape some of the holder back a bit so it doesnt catch any other components near the nand?
and have you try'd swapping the clips? do you get the same results or is it better / worse?
make alot of dumps then compaire them with a similer dump from the wikki. really make sure your getting 100% good dumps
let me know how you get on but now you have solved this i wont be on as much while i try to get the nand side typed up.
--------------------------------------------------------------------------------------
un-related
what is the E3 nor clip like? is it a nice fit or does it need clamping aswell if its to be used as a downgrader? (i assume the heat sheild holds it in place if its used for duel boot