PS3Hax Network - Playstation 3 Hacks and Mods - View Single Post - Installed E3 flasher limited but need help

Bigbones87 · 09-01-2012

I mean I would. I am not an expert on troubleshooting the e3 linker, or anything, but i work with low voltage everyday. It wouldnt hurt to see what you get. Put it on dc power meter and then put red on the VCc and black on a ground and see what you get. It should be 3.3v or there abouts.
************* [ - Post Merged - ] *************
That would tell you if you are getting good power to the flasher. I am assuming this is where it gets power from, since it is the only source for power.
************* [ - Post Merged - ] *************
Try this at your own risk, as I have never done this before on ps3. This is jut simple troubleshooting technique.

09-01-2012	#40
Bigbones87 Senior Member Join Date: Jun 2012 Posts: 1,355 Likes: 241 Liked 419 Times in 300 Posts Mentioned: 118 Post(s) Tagged: 0 Thread(s)	I mean I would. I am not an expert on troubleshooting the e3 linker, or anything, but i work with low voltage everyday. It wouldnt hurt to see what you get. Put it on dc power meter and then put red on the VCc and black on a ground and see what you get. It should be 3.3v or there abouts. *********** [ - Post Merged - ] ********* That would tell you if you are getting good power to the flasher. I am assuming this is where it gets power from, since it is the only source for power. ********* [ - Post Merged - ] *********** Try this at your own risk, as I have never done this before on ps3. This is jut simple troubleshooting technique. Last edited by Bigbones87; 09-01-2012 at 09:45 PM.