PS3Hax Network - Playstation 3 Hacks and Mods - View Single Post - E3 Flasher downgrading tips [NOT guide] + Unbricking without soldering

Bigbones87 · 09-02-2012

@xtsgeditz did you not read the post above? I told you can probably still get a bios dump as long as you haven't already flashed over the per console data. Solder a wire from the nor tristate to the sbe on the e3 flasher ribbon and then put switch 1 and 3 up. Turn on the ps3. It should turn on and stay on. Then hit start on the e3 Flasher and it will start a bios dump. If you get an error 10001100 then the clip isn't seated good enough. Try to reseat the clip and tape something on top of it to get constant pressure.
************* [ - Post Merged - ] *************
Then after you get a bios dump, then check it for validity using Flowrebuilder. There are guides on here for checking dumps or use ps3devwiki. After you confirm they are good, then you can patch them and reflash them back to the console. There is also a guide on here for that.
.

09-02-2012	#16
Bigbones87 Senior Member Join Date: Jun 2012 Posts: 1,355 Likes: 241 Liked 419 Times in 300 Posts Mentioned: 118 Post(s) Tagged: 0 Thread(s)	@xtsgeditz did you not read the post above? I told you can probably still get a bios dump as long as you haven't already flashed over the per console data. Solder a wire from the nor tristate to the sbe on the e3 flasher ribbon and then put switch 1 and 3 up. Turn on the ps3. It should turn on and stay on. Then hit start on the e3 Flasher and it will start a bios dump. If you get an error 10001100 then the clip isn't seated good enough. Try to reseat the clip and tape something on top of it to get constant pressure. *********** [ - Post Merged - ] *********** Then after you get a bios dump, then check it for validity using Flowrebuilder. There are guides on here for checking dumps or use ps3devwiki. After you confirm they are good, then you can patch them and reflash them back to the console. There is also a guide on here for that. . Last edited by Bigbones87; 09-02-2012 at 05:48 PM.