Ah, more interested parties. Well, I'm working on something that hopefully should work, but it's not done yet. I think it's just a matter of time.
But just to answer your question player, I did try using that second lv2. I don't know why since I knew it would brick, but I did it. And it bricked. So I went through and put my 4.11 (or whatever it is) backup back on and got to where I was again. And then, after trying a couple things, I put all switches down (OFW mode) and it told me things were in bad shape, please put in a usb stick with OFW 4.11 or higher. So I'm downloading it now and my plan is to get it back onto 4.11 OFW, then start from square one using Rogero.
Should work, right?
************* [ - Post Merged - ] *************
Oh, and the fact that it asked for 4.11 or higher means that it is running 4.11 firmware. I was restoring 4.11 to the OFW mode and not the CFW mode, right?
Either way, I think it's going well.
************* [ - Post Merged - ] *************
Spoke too soon. BSOD.
************* [ - Post Merged - ] *************
Ok, so I got everything back to normal and I started the whole process over again.
I got to step 5 on
this tutorial, but I don't get the message asking me to insert a controller. It's just a black screen.
According to this
Normal E3 downgrade Process, it says I should have the downgrade bin and the backup bin both on the sd card, but that isn't mentioned in the tutorial I'm following. It also says something about patching the backup bin.
I'll work more on it tomorrow, but for now it doesn't boot anymore.