Originally Posted by poyeshsoft
I have a big Problem.
I installed driver and set bitstreem for NAND CLIP
but i can't domp nand?
the can not go and stayed in dumping block 0
I used external power 3.3v and no change
please see and IF you can help me
image
|
i had this myself last night. i found the usb cable was faulty. try changing yours (also short usb cables work better than the longer ones)
if both
@
playerkp420
reply and my reply have no affect then double check the clip is on flush / propperly and plugged into the A side of the adaptor
************* [ - Post Merged - ] *************
Originally Posted by achilles_85
Hi guys! There was a problem. PS3 slim 2008A, broken pin ry/by. With progskeet 1.1 crystal blue I buught 360 clip-56. How can i use it with my NOR? I found on WIKI about pin 48 on the clip, but i dont know how it connect. NOR tristate and VCC pins - they must be soldered to progskeet?
|
i havent found a fool proof way to use the clip as yet.
you need to remove the 2 pins 46 & 48 there both linked to the earth and so shorting out the progskeet.
also there tiny. there hair thin so make it realy hard to remove.
in the "diagrams" folder you will find "ps3" folder in there are the board diagrams.
you will see the ps3's solder points marked up and the progskeet marked up.
find your board and you should find trist on the progskeet (near the usb) and this goes to tristate on ps3
-----EDIT-----
do not connect the 3.3v if your powering up the ps3 (this is the normal way)
only connect it if your un-bricking (as you wont be powering up the ps3)