|
just need a wire. I have also used a bread tie. Just strip back a little on each end and tinge them with solder before soldering them to the ribbon and board. BE CAREFULL on the motherboard and the e3 ribbon cable. You can always replace the ribbon cable if you over heat it and pop off the solder pad, and there is also an alternative point on the flasher itself, but if you overheat the ps3 motherboard and unseat the nor tristate than you will be in big trouble and will most likely be throwing the ps3 away. I checked your dumps and they seem to be good, although I am not an expert in this field. I have validated mine before but i wouldnt feel comfortable saying yes to yours without having someone else more experienced look at it. It looks like you have a chechLxx motherboard with a min version of 2.45. Here is the part i cant understand...your ros0 and ros1 files seem to be from 3.50-3.55 ofw. What firmware where you on when you got these dumps?
|