Originally Posted by Kazrael21
Hello so I am trying to program my progskeet v1.2 and I am following Baileyscream's guide but my computer keeps telling me "USB device not recognized" and when I try testing for shorts it gives me the error code "device not found! Please check all leads on U2 and leads 50 though 75 on UI"
so all I have done is download the Nand file from Baileyscreams thread, so now winskeet4000 is on my computer. I conncted the usb cable to the smaller black chip that came with the progskeet, then I connected the 80c 60v vw-1 ribbon cable (the long skinny one) to the progskeet. and connected it to my laptop.
What am I doing wrong?
************* [ - Post Merged - ] *************
okay so here is a photo of everything i was connecting to my computer and how i had it all connected, the other is a photo of my v1.2 pprogskeet. I noticed that (c3,c4,c7,c8,c13 and c14) seem to be soldered very poorly compared to the photo that the wholesaler had on their website. would this have any affect on the chips performance?
|
look at your image o the prog
c11 looks like it is shattered
i can also see resistors missing ie r8? if it works the same as v1.1 then that should be connected to be detected by pc ie r8 powers prog via usb
BUT DO NOT CONNECT IT YET let me look at the prog site to see if i can get some info about this board
************* [ - Post Merged - ] *************
@
Kazrael21
have you updated the bitstream for the progskeet?
it doesnt have anything on it when you buy them
you do have the injectus for programing?
and i see a switch on the side of the slave board
does that do anything when connected to the pc?