Originally Posted by Stolas
Well I tried soldering the v3.3 together, but I still only get unknowns when I click the auto button. This sucks! I was hoping for a quick downgrade solution :P
|
Do you have a NAND mobo? did you make sure to install the new bitstream, usb drivers on the progskeet webpage? make sure you use some cleaning alcoohol and a clean toothbrush(any clean brush) to cean the pins. im in the same situation as you but just want to make sure youve tried all these solutions, and if your using a 360clip it difficult to make it sit flush with the board due to all the tiny resistors aligned around the NAND chip so make sure you file the 360clip just enough so it sits flat against the motherboard. try some ofl these and see if it works