Originally Posted by Decoy
I have flashing problems .. With the Samsung K8Q28... Always errors when verifying .. I'm using the one word program , and the rest won't change anything :/ , what's my mistake ?
|
hiya Decoy
i'm full of man flu but i will try to help you
i have the exact same chip that i flashed once and it worked with the above settings but due to a corrupt usb stick i bricked it after de-hash by installing rebug (the mem stick was currupt not a de-hash brick)
now it refuses to flash the patched dump back a second time.
i have tried powering the ps3 via progskeet but it did nothing.
i have tried grounding the tristate but i have got just say 80% to verify
after flashing.
if you try powering the ps3 via prog its 3.3v point on prog to vcc on ps3
and gnd/vss on prog to vss on ps3
dont powerup the ps3.
turn on prog and see if you can flash (i just had a halt)
the other way is ground out the tristate turn on ps3 (dont connect 3.3v to ps3) and the ps3 should halt wait 10-15 sec then power on prog
see if you get 80% or more to verify
btw what board have you got?
************* [ - Post Merged - ] *************
Originally Posted by erubarral
Hi
Could someone please tell me if the PS3 CECHE01 (PHAT/80GB/RETRO/4USB) with slide-HDD (not the one that goes directly into the tray, but the one you have to slide to the right and adjust with a screwdriver) can be downgraded? I already asked around various hackers, but they said id was impossible at the time because they had no schemes...
I'd like to have my PS3 wit cfw for christmas 
Thx
|
that ps3 model can be downgraded
you wont find a schematic / wiring diagram for the CECHE as you need to open it and see what board is inside.
then you will find a schematic / wiring diagram for the BOARD
************* [ - Post Merged - ] *************
Originally Posted by freestylemaster
thank you so much really. I hope the dump is good.
************* [ - Post Merged - ] *************
Checking sector protection...
No protected sectors found!
I got this in the cmd before dumping the nor with teensy. Is this an error*
|
i didnt see that when i did it.
did you reset your pc after you installed everything?
it may be worth doing a re-start then do a second dump and see if you get the message again.
if not then do a compaire and see if the dump is different