Originally Posted by dooma
no no I typed wrong code I got 10001100
************* [ - Post Merged - ] *************
I have few questions 
1. I soldered tristate to gnd and ps3 stays on, can I brick it again?
2. Do I need to cut that wire when I got connect controller screen?
3. I got error 10001100 after trying to flash bios with bkpps3.bin, what is that?
|
That error means the clip is not on good enough. Reseat the clip.
Once you get the clip on good, make some backups and validate them. To make sure the clip is on good.
Then flash your patched bios. Remove the wire. And continue with FSM downgrade.