Originally Posted by Sarah1331
Ok so I just dumped a cecha00 and bottom NAND dumped 132mb and top only 33 but if I interleaved theses two I can verify 100% every part of the verify guide any ideas
I have dumped loads and still only get 33mb
|
very strange.
what firmware is it on?
can you update it to a higher firmware and dump again and see if you get different sizes.
the fact it validates says its ok but the dump sizes say its not.
it may be best asking on irc just to make sure. or
@
master737373
may be able to give more insite.
can you upload the dump then if master comes in he can take alook at it.
************* [ - Post Merged - ] *************
Originally Posted by the_lost_soul
hi all i just revived my E3 Flasher Limited edition kit + E3 Card reader and Prankster AVR reprogrammed as the ecliPS3 Downgrade dongle.
still waiting on my breadboard jumper wires to arrive so i can solder on the E3 linker.
just spent 3 hours disabling and reassembling my PS3 as a practice run.
hare are some pics:
https://www.icloud.com/photostream/#A3GWZuqDGmXx4P
i never knew that the pin's are so small and the E3 Linker is tiny + the pins to solder on are even smaller...
This PS3 slim strip down in this guide was Da Best!
but my PS3 had a few different connections like a ribbon cable connecting to the motherboard in a socket.
the blue-ray drive was the most difficult as there was a short ribbon cable underneath it. and pluging that back in was a pain!!
|
yea i have alot to update in the guide
adding the chech-25++ stripdown will be done at the same time.
i just have a problem ps3 that i am putting all my time into at the moment.
i will update soon though