Originally Posted by plugbroken
so you means without the traces it cannot solder it back?
|
on the other side of the board there are also traces for the same points, so it should work again, but since you don't have that much experience with soldering, (even for people with experience these solder points can be too small)
it's best to have it repaired..
technically two points can even be soldered by an ape, because there's no way you can screw them up.
in this case i'm talking about soldering wires, and not the connector, but the third point, need a little patient, and it's probably on the back side of the board.