Ok, i decided to just continu with the E3 flasher clip, i will unbrick using Original Dump and by soldering SBE from the E3 Flasher board cause i don't want to damage the Flat Wire. I will try with only electric tape as i will only get soldering iron tomorrow.
i will put tape all around the Nor tristate spot to make sure it doesnt touch anything else then tape a wire on that spot and had presure to keep it in place cause i am impatient lol worth a try a guess.
Think it would work ?
Last edited by JohnnyBoyQC; 12-06-2012 at 08:14 PM.