Have you got an original Gamecube control pad lying around, being unused, now you can use the control pad on your Wii or WiiU, there is a catch though, you need to have some skill with soldering, here is a quote between the modder and the source:
Gametista.com: How long approximately did this take?
gummowned:Â*It took me 10 hours from start to finished. I started around 5pm on Monday and didn’t complete it until 3am. Mind you I had no idea how exactly I was going to go about the mod when I started since there was no type of guide or anything for such a mod like this. Now that I know what to do it will take only a few hours to make another one.
GT: What were the parts you used?
gummowned:Â*A [Wii Remote] to test with. A Wii Classic Controller to cut up and fit into the [GameCube] pad. 30 gauge wire (has to be this size). A Dremel to cut the [Classic Controller's] PCB. A [GameCube] pad to mod. Of course a soldering iron and solder. Tri-wing screwdriver helps to open up the pads and a continuity tester helps too.
GT: Are you planning on putting a guide out so that others can follow suit.
gummowned:Â*I’ll be working on a guide but the mod is pretty difficult because it will involve soldering very tiny wires to very small traces on the PCB.
SourceÂ*Gametista
For Full Story Click This Link --->
http://bit.ly/ZTbfMh Author Of Story GregoryRasputin