ok so i have been on for 5 days and i still haven't managed to get a decent dump. the clip does not sit on the spansion chip tightly and I have tried all different methods of applying pressure. i have sanded down the clip i have tried with pads on top and also coins on top. but i get the same error every time 10001100. I have tried this on a dia 001 board and 2 jtp slim boards. same error every time. I did get 1 good dump from the phat dia board but it would not byte reverse using flowrebuilder, so i tried reseating the clip and now it's back to the same old story of the dreaded 10001100 error code. grrr........ Looks like i'm gonna have to either buy a new clip or try my hand at soldering. Unless anybody here can suggest something i maybe missing.
Last edited by donkey-punch; 12-21-2012 at 08:24 AM.