Originally Posted by magic_marty
so if i use the progseek i know up front i have to solder it to the board or use the clips ..with the progseek 1.2 do i need the injectus jtag? i read somewhere the 1.2 does not require it.
i guess im just not 100% sure what i need if i decide to use progseek cause of there beinf different versions available..with the E3 it comes as a kit with nothing else to buy separately...
|
if you buy from
http://www.siliteo.fr/
this is what you get
. the progskeet 1.2
. the progskeet usb adaptor
. the injectus
. the "Y" adaptor board (for dual nand)
. a 50pin ffc for progskeet to "Y" adaptor
. ffc cable for progskeet to usb adaptor / injectus
. 2x ffc cables for "Y" adaptor to NAND clip (not included) or the mentioned qsb maybe? (also not included)
the progskeet 1.2 you get just the progskeet board
you need
injectus (to program the bitstreem for NAND)
"Y" adaptor
NAND clip
get
@
Sarah1331
's board and you dont need the injectus or the "Y" adaptor
as it makes the prog "plug and play" no swapping bitstreems (or forgetting to like i have a few annoying times) when you swap from NOR flashing to NAND flashing
*******************edit***************************
after reading some poorly translated french (thats me trying to translate)
the items
. the injectus
. the "Y" adaptor board (for dual nand)
may not actually come with the prog 1.2
mine was sent to the wrong address by mistake and these could have been added as an appology from the above site.
@
Sarah1331
did you get yours from the same site?
if you did did you get these items as part of it?