[ai3643]

Hey everyone, I finally got my E3flasher to do a good dump thanks to all the help on here, now I seem to be stuck again. I'm following this guide and I'm at the part

Finishing the down grade in service mode

In the previous step, the One Key downgrade, everything went as it should have,

I then took out the E3 card, just the card, not the NOR clip. And Then I put the HDD in. When I turned on the PS3 it went to the main menu like normal, I did'nt get the "Connect the controller" screen.

Then I thought I would try putting the E3 card back in the HDD slot and putting the HDD back in the ESATA Station, but the same results. I did'nt retry the following step before trying the station again though.

Any Ideas?


Also, If I just go ahead with the DEV board I do the power Eject and the TV stays black, the devboard lights up and after 5min or so the PS3 turns on and goes to the main menu like normal.