Originally Posted by JAGULAR1974
Mr Dutch
Do u think I should just due solder the port as my soldering techniques could accommodate the larger solder points would this be the same as due soldering th3301
|
i don't know how small these traces are, but as an alternative you could decide to cut one of the traces i marked.
if you scratch some of the protection layer off you can put some solder on it if the cut was unneeded afterwards?
if you cut the trace i marked near the usb port, you can measure on both sides where the 001 ohm comes from.
if you cut near the TH3301 the usb ports should not influence the ps3 anymore. (in my opinion)
if you decide to cut then measure if it's really cut with your meter.
