E3 guide updated
the patching with flowrebuilder was telling ppl to use the origional dump instead af the bytereversed dump
all fixed now
thanks
@haz367
for the heads up
************* [ - Post Merged - ] *************
Originally Posted by daveyaz
Hi...
i got e3 flasher
i followes this guide and was success downgrade phat ps3...
now i did the same on slim ps3 cech2504A...
i did a flash dump
i checked it my self,,,looks good and valid
i uploaded my dump for checking and was told here it is valid.
i used one key downgrade by E3....lights stopped flashing...lights started ligh one by one,,,and suddenly lights was flashing....i press stop....tried again....now my ps3 power on for 2 seconds then power off...power light is off...but if i press it it tyrns red and once again i press it,,it powers up for 2-3 seconds and power off ?!?!!?
any idea...PLEASE
|
can you cut and paste the txt file that would have been on the sd card when you tried to do the patch.
you will now need to solder sbe on the ribbon to the sbe on the board.
see the soldering section in the guide for the sbe point
then have flashfun switch up while doing the downgrade patch again.
but post that txt file first
************* [ - Post Merged - ] *************
Originally Posted by jensen76
tryed that and everything is the same.dumps are all the same...
only thing i can try is new usb stiks.. there is 1 bad block on cpu side so im giving op now.dont know how to fix it.the consol works fine when i flash stock nands back.only thing i cant get i to do is read the pup fil in service mode.tryed 5 usb stiks,3 harddrives.nothing is working.
here are the nands on CECHG04 sem-001
|
i will sleep on this ang get back to you tomorrow.
dont be thinking i have forgotten about you
