Originally Posted by daveyaz
i got e3 flasher
i followes this guide and was success downgrade phat ps3...
now i did the same on slim ps3 cech2504A...
i did a flash dump
i checked it my self,,,looks good and valid
i uploaded my dump for checking and was told here it is valid.
i used one key downgrade by E3....lights stopped flashing...lights started ligh one by one,,,and suddenly lights was flashing....i press stop....tried again....now my ps3 power on for 2 seconds then power off...power light is off...but if i press it it tyrns red and once again i press it,,it powers up for 2-3 seconds and power off ?!?!!?
any idea...PLEASE
|
Originally Posted by daveyaz
Is there an answer....some nice guy here at the forum told me that i need to connect a wire between two points on the board and then continue downgrading as regular......
|
Originally Posted by daveyaz
Is there a solution for this.........................?????????????????
Thanks
|
solder sbe on the ps3 to sbe on the E3 ffc cable (found half way along the flex of the clip) find your board in the soldering section of the guide under "setting up E3" to see where the sbe point is
then do the patch part of the guide again with "flash fun" switch up. switches 2 3 4 5 down 6 up
it should take 10-15 minimum to flash.
once done turn off ps3 put "flash fun" down and see if ps3 turns on