Originally Posted by blackjacker_21
i was using the cable for backup.
now i got the whole picture about this.
i'll just have to think which way to choose(if i solder the tristate to ground then i won't be able to check it the writing was succesfull, and that will be a problem because i have samsung nor and the clip it won't stay properly seated on the nor so i'll have to repead the process a few times until i get a good writing. on the other hand if I solder the tristate to the clip i might damage the clip because it's so thin and even if i don't damage it i don't think i wanna do it this way but i think it's the most convenient way)
i have to think about this
thanks for your support
|
To make sure you have a good connection, you can flash your valid dump. Then make a backup, and do the file compare under the analysis tab in HxD.
If they are identical, the clip is on correctly.
Or you can use this SBE point (see pic) on the flasher. Instead of on the ribbon.
