Originally Posted by xAfgkiller96x
What do i have to do?
i have one black and red cable , like which points do i have to connect ?
|
ok, i have 2 pics, one from side A of the board and one of the B side.
i added your meter in the first picture , so you can see how to turn the knob.
maybe you should first try to measure a battery to see if you have the meter hooked up properly, you know the voltage of the battery so you know what you should read with the meter.
so you meter is set to 20V range, if you turned the know like i showed in the pic.
in both pictures i added an example of how to connect the probes to the board.
in the first picture i show how to measure point 1, and in the second one how to measure point 8.
as you can see the black probe is connected to ground, and ground is everywhere, you can even put the black probe to the metal housing if you find that easier.
the black probe dousnt have to move, you can keep it on the same point, only the red probe moves from point to point.
in the zoomed window (first picture) you can see there are more ways to measure point 1, but i marked points to not get confused....i hope.
i added more points then we need, but i need as much info as possible.
there are 12 test points, just read them with the meter, and write them down.
if you post the readings starting from point1 to point 12, i will let you know what to solder.
just to get you started, point 3 should read 3,3V. (on the meter it can read 3.41)
if you have any question, ask
@
baileyscream
EDIT: for some reasons imageshack rotates the pics...lol
