[Console_Wrecker]

Ok so I'm almost finished soldering all the wires to my progskeet (from the mobo)... But i'm unsure of one of the instructions...

WP#/ACC tied to Vcc
BYTE# tied to Vcc

Can someone please explain the step above?...

I don't see WP#/ACC or BYTE# anywhere on the diagram..

Btw my mobo revision is JSD-001..

Also i have the v1.1 crystal blue progskeet... is removing R8 still necessary?

Any helps appreciated...

[jhax78]

Originally Posted by Console_Wrecker Ok so I'm almost finished soldering all the wires to my progskeet (from the mobo)... But i'm unsure of one of the instructions... WP#/ACC tied to Vcc BYTE# tied to Vcc Can someone please explain the step above?... I don't see WP#/ACC or BYTE# anywhere on the diagram.. Btw my mobo revision is JSD-001.. Also i have the v1.1 crystal blue progskeet... is removing R8 still necessary? Any helps appreciated...

ignore the

WP#/ACC tied to Vcc
BYTE# tied to Vcc

r8 needs to be removed if you have a 3.3v from the ps3 soldered to 3.3v on the skeet (your case nor vcc to the 3.3v on the skeet)
r8 is used to power the skeet over usb
if you remove it and have 3.3v soldered the skeet will be powered when
you boot the ps3

btw remove r7 place a switch
set the switch to off boot the ps3 after 10 seconds close the r7 switch
this way the ps3 is halted and you can dump the flash
if you have more questions please come to irc we have some nice people there and im most of the time on it too

Server: EFNET
Channel: #progskeet-support


http://chat.efnet.org:9090/

Under the 'Connect to EFnet IRC":

Enter a nickname. (Mine would be jhax78)
Enter a channel name. (ProgSkeet support would be #progskeet-support)

The chatroom will then load up - and you'll be able to chat with us!

[Console_Wrecker]

Thanks for the fast reply... i probably would of been scratching my head through the whole night trying to figure it out...

[jhax78]

oh and please dont use some outdated tutorial that only tells you to verify the filesize as there where already 4 people that flashed their ps3 with a bad flash
resulting in a brick beyond repair

jhax

[jhax78]

Originally Posted by Console_Wrecker Thanks for the fast reply... i probably would of been scratching my head through the whole night trying to figure it out...

sorry i disappeared all of the sudden we had a power outage due to lightning

did you manage to dump the nor again?

[Console_Wrecker]

Originally Posted by jhax78 sorry i disappeared all of the sudden we had a power outage due to lightning did you manage to dump the nor again?

i didn't , left it for the night (was about 5am) but i'll be on the irc today.. and i have another problem (could be nothing)...

I did do a dump today but noticed a wire came off so i don't think it was a complete dump.. re-soldering and dumping again...

see ya on the irc.. tnx

[Snaydher]

Originally Posted by jhax78 oh and please dont use some outdated tutorial that only tells you to verify the filesize as there where already 4 people that flashed their ps3 with a bad flash resulting in a brick beyond repair jhax

Do you have a new tutorial?