|
|
#1 |
|
Apprentice
![]() Join Date: Dec 2011
Posts: 14
Likes: 0
Liked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
I sucessfully downgraded my ps3 from 3.7 to 3.55 (KMEAW No Check) using progskeet and ti-84plus.
But then I wanted to install rebug CFW so I tried to install OFW 3.55, but my PS3 bricked. Already tried going service mode and recovery mode without sucess ![]() What can I do to unbrick it? Many Thanks Last edited by Snails Inc; 12-26-2011 at 04:54 AM. |
|
|
|
|
|
#2 |
|
Senior Member
![]() Join Date: Sep 2011
Posts: 1,644
Likes: 436
Liked 856 Times in 462 Posts
Mentioned: 80 Post(s)
Tagged: 0 Thread(s)
|
1. You cannot use OFW. The lv1 checks are in place, they have to be disabled for a FW to work on a downgraded console.
2. You do not need to go to OFW to go to Rebug CFW, but you would need to disable the lv1 checks on the Rebug CFW. 3. From what I understand, you are SOL unless you have a bios dump of your PS3.
__________________
![]() |
|
|
|
|
|
#3 |
|
Apprentice
![]() Join Date: Dec 2011
Posts: 14
Likes: 0
Liked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Can't I use progskeet again to dump once again and flash the nor?
|
|
|
|
|
|
#4 |
|
Senior Member
![]() Join Date: Sep 2010
Location: Ireland
Posts: 1,048
Likes: 1,805
Liked 520 Times in 300 Posts
Mentioned: 106 Post(s)
Tagged: 0 Thread(s)
|
You don't need another dump, use the dump you took before you downgraded. It's because you haven't got the lv1 patches (that bypass the check to see if you're on the right FW) you're bricked, the PS3's bricking because those lv1 checks are failing.
What I'd do is: flash back the original dump (3.7x) and start over.
__________________
1x Slim 2K REX | 1x Slim 2K CFW | 2x CECHG CFW | 1x CECHJ REX | 2x CECHC CEX2DEX 1x Jasper 256 SMC+ROL+Halo case | 2x Jasper 16 RGH | 1x XD mod Slim RGH Matte+Chrome+ROL RGLoader/Freeboot/Retail | 1x Banned Slim RGH+ROL |
|
|
|
|
|
#5 |
|
Apprentice
![]() Join Date: Dec 2011
Posts: 14
Likes: 0
Liked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Is there any way to flash the 3.7x dump like from other ps3? I don't have the dumps I used for the downgrade :S
|
|
|
|
|
|
#6 |
|
Member
![]() Join Date: Dec 2010
Posts: 132
Likes: 18
Liked 68 Times in 32 Posts
Mentioned: 4 Post(s)
Tagged: 0 Thread(s)
|
I think there is no way since the dumps contain some per-console parts, if you don't have original dumps you are out of luck, only thing you can do is have a nice paperweight or sell it for pieces (like HDD, Blu ray drive).
Someone should sticky this or something, so other users have warning, there are way too many bricks due to people not doing backups. |
|
|
|
|
|
#7 | ||
|
Member
![]() Join Date: Nov 2011
Posts: 631
Likes: 70
Liked 165 Times in 109 Posts
Mentioned: 34 Post(s)
Tagged: 0 Thread(s)
|
if you do flash this back to the console and start again you should always keep a good bin for backup just for cases like this ************* [ - Post Merged - ] *************
people are warned enough it's just a matter of searching the forum tbh |
||
|
|
|
|
|
#8 | |
![]() ![]() Join Date: Sep 2010
Posts: 1,035
Likes: 702
Liked 263 Times in 191 Posts
Mentioned: 31 Post(s)
Tagged: 0 Thread(s)
|
|
|
|
|
|
|
|
#9 |
|
Apprentice
![]() Join Date: Dec 2011
Posts: 14
Likes: 0
Liked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
Hi there people
![]() After all the day trying to recover the ps3 from brick state without the "original" dumps i was able to unbrick my PS3... I just dumped my fuc*ed up firmware (something like KMEAW no check / 3.55 OFW) and remodded it with the patches. Re-Flashed it and my PS3 was UNBRICKED :D |
|
|
|
![]() |
| Bookmarks |
| Thread Tools | |
|
|