[Chronicle]

Hi there.
2 days ago I got brick on PS3 when I do downgrade with e3 falsher.

Here is my story:
I got PS3 with 4.11 OFW and try downgrade it to 3.55
First what I do is create dump. All gone perfectly.
Then I remove original HDD and insttall in esata station my other HDD and then will do downgrade. All process gone normally.

After all proccessing downgrade I will shut on PS3 and will see message what is sayed I need install 4.11 FW, I try it and it's sayed what i have corrupted data.
Then I will tryed restore PS3 with backuped dump. Fist momments gone perfectly then I got error on E3 10001111, but PS3 turns on normally.
Then I will try again do downgrade, but in this time I'm not do backup dump.
After doing step with downgrade.bin I shut down PS3, try turn on and got brick. PS3 turn on and after 2-3 seconds turn off automatically and red led is off.
I tryed do unbrick but E3 show me error 10001100 and 10001111 then I resolder wire on e3 clip SBE point. I do little whole on SBE point and I just put wire in SBE whole point.
Then I tryed go PS3 in FLASH FUN mode but it's too shutdown after 2 seconds when I turn on PS3

Is this can be unbricked? Or not, or I just need new clip? Help anybody
sry for my english

[CrystalWolf]

Well, what firmware version did it come out of the box when you got it, if you got it at 4.11 OFW then there is possibly no way to downgrade even with the e3 as it will result in a brick. That's all I can say for now.

[Chronicle]

Originally Posted by CrystalWolf Well, what firmware version did it come out of the box when you got it, if you got it at 4.11 OFW then there is possibly no way to downgrade even with the e3 as it will result in a brick. That's all I can say for now.

if you mean factory firmware, it's was 3.40
if you mean what is FW was when I got brick, it's was 4.11