[domelec]

check clip is seated good

[Scotch_be1]

Originally Posted by domelec check clip is seated good

normally it i putted something on the metal cover of motherboard to press on it but i will look right away!
you have skype?

[domelec]

join #ps3downgrade on irc

[Scotch_be1]

Originally Posted by domelec join #ps3downgrade on irc

it's down for repair

[domelec]

its not im on there now with lots of others
its on efnet server

[Scotch_be1]

Originally Posted by domelec its not im on there now with lots of others its on efnet server

the site is blocked i my country
************* [ - Post Merged - ] *************

Originally Posted by Scotch_be1 the site is blocked i my country

anyway im going to check the clip in 10 min. i hope you will be still online il pm you on ps3hax.com when im finished

[Scotch_be1]

Originally Posted by domelec check clip is seated good

Wilde checking the clip, i broke solderen wire and broke sbe solderpoint but i orderd a new clip with softboard already but thanx for your help anyway i Will post it when i have recieven the new clip

[domelec]

no need
just solder a wire from gnd point on ps3 to tristate point

[Sh4n]

i had the same problem but i had a led error when i wanted to unbrick.
The dump was 100% OK but while the writing process (samsung pi4b), the e3 flasher blocked at led 2 ! then i pushed RESET in the e3 flasher board without shut off ps3 then i pushed START again the e3 flasher block at led 3 !
I checked the log and i saw failed to write on a sector...
I re-opened i didn't touch the clip i just put more thing on it and re-closed.
I retried unbrick and the process was fine ! \o/
i wanted to retry the downgrade process but SAME PROBLEM AGAIN the e3 block at led 3...
but i managed to unbrick again...
It was a ps3 2004-a samsung pi4b horizontal position but i took a picture but we can't see the letters :/

PS: I gave back the console but i suppose the clip may lose contact with time...
What do you think about it?

[Scotch_be1]

Originally Posted by domelec no need just solder a wire from gnd point on ps3 to tristate point

i just did this but that doesnt work, my ps3 turns off, but i have seen that vcc is soldered with another point, is this normal?