[domelec]

dont understand u
what u mean soldered with another point?

unsolder it and instead of soldering to gnd on ps3 try to solder it to the sbe point on e3flasher like i posted in other thread.

turn the flasher over with faceplate facing u
the points that are the connector for the faceplate when u count from right to left the third 1 in is the sbe point

[Scotch_be1]

Originally Posted by domelec dont understand u what u mean soldered with another point? unsolder it and instead of soldering to vcc on ps3 try to solder it to the sbe point on e3flasher like i posted in other thread. turn the flasher over with faceplate facing u the points that are the connector for the faceplate when u count from right to left the third 1 in is the sbe point

i mean that the points bvcc and vcc on the e3 flasher are connected to each other so i soldered my wire from pa0 nor tristate to 2 points: bvcc and vcc.
and for the sbe point, i lost that point so i cannot solder on it anymore, so i tried as you said to solder the wire on vcc instead of sbe but the vcc point is connected with the bvcc point with tin so i soldered my wire from vcc and bvcc to tristate point.
But this doesnt work, i put ps3 n flash fun and it turns off automaticly.

Please help

[domelec]

i have no idea what u are talking about bvcc ????

i said to solder a wire from tristate to gnd on the ps3 nothing to do with the e3flasher
or if u want the sbe point ( the 1 u have lost ) it can be found on the bottom of the e3 as i have described in the above post

[Scotch_be1]

Originally Posted by domelec i have no idea what u are talking about bvcc ???? i said to solder a wire from tristate to gnd on the ps3 nothing to do with the e3flasher or if u want the sbe point ( the 1 u have lost ) it can be found on the bottom of the e3 as i have described in the above post

i soldered the tristate to the vcc point on my ps3 motherboard but my ps3 keeps turning off, i made a cable with paint on the photo how i soldered:
http://www.imagebam.com/image/3b0b78178963279

Is this right?
If not please show me on a photo where i can find the other sbe point on e3 flasher.

Please help.

[domelec]

yes that is right
but if u are in a fully bricked state u might need a progskeet and to solder to testpoints to fix

[Scotch_be1]

Originally Posted by domelec yes that is right but if u are in a fully bricked state u might need a progskeet and to solder to testpoints to fix

is a corrupt bios a full-brick?
If it is, will a teensy work to?

Please help

[domelec]

if u dont have a good working dump then yes its a full brick and nothing u do will recover it.

[Scotch_be1]

Originally Posted by domelec if u dont have a good working dump then yes its a full brick and nothing u do will recover it.

i dont mean the backup bios corrupt but the bios on the ps3 flash, you checked my backup and you said its a good one.
Could i use a teensy to recover from my brick?

[domelec]

sorry forgot
if u have a teensy then yes it should be fine to use to reflash

[Scotch_be1]

Originally Posted by domelec sorry forgot if u have a teensy then yes it should be fine to use to reflash

but if i would buy a new clip with softboard at the same price of a teensy, wouldn't that be better, than i will have the sbe point again.

Please give me your second opinion