[aneeshchennai]

can someone post a exact picture of motherboard point? i hope have done at correct point

[nzie]

Originally Posted by aneeshchennai ya i tried.., flashfun- 1 up and all down...same thing..ps3 shuts off i hope i have soldered the right point on motherboard..its a 120gb board

dump is good?

@nzie i cannot write both backups (3.55 and 4.11) ive reseated the clip again ... should i try it again?

reseat the clip then try reflash
************* [ - Post Merged - ] *************

Try this ,flash original dump,once finish dont turn off ps3 switch to 000001.then take out sd card and transfer e3downgrade.bin into sd card.push reset button then push start button

lol this method to unbrick on 3.55+

if you brick on 3.55 then just solder point to keep ps3 stay on then reflash 3.55 dump . make sure you've verify the dump 1st

[abs298]

just going to try and reseat the clip
************* [ - Post Merged - ] *************
im still getting the 10001111 error any suggestions?

[aneeshchennai]

hi good news... flash fun mode working.. ps3 remains turned on... i pressed start and it did something.. i think it wrote my good bios dump into the ps3.. yes...

now wat do i do???? If i turn to ps3 mode... the system does the same problem.. wat does this mean?
but if i keep in flash fun mode its ps3 running ok-no turning off

[nzie]

Originally Posted by aneeshchennai hi good news... flash fun mode working.. ps3 remains turned on... i pressed start and it did something.. i think it wrote my good bios dump into the ps3.. yes... now wat do i do???? If i turn to ps3 mode... the system does the same problem.. wat does this mean? but if i keep in flash fun mode its ps3 running ok-no turning off

dumps are good?which point did you soldered?

[aneeshchennai]

the tristate only... i hope my solder is good otherwise my system might have turned off in flash fun mode..it stays turned on and it s flashing my (own)bios now.

[abs298]

okay well I got a bit of news, today I tried to see if my clip was fitted on wrong and to prove this I tried to back up the ps3 (I know that its bricked but its worth a shot) any way it backed it up with the 8 led's and then when i connected it to the pc and checked it with the e3 nor checker it came up (check your hardware)... what do you reckon ... re-seat the clip again ? !

[hellsing9]

Reseat again and check 101000, just in case. @abs298 the pc is checking the dock with your HDD not the PS3.

[abs298]

Originally Posted by hellsing9 Reseat again and check 101000, just in case. @abs298 the pc is checking the dock with your HDD not the PS3.

Okay so I reseated the clip (shaving only very slightly the sides as there seemed to be a component in the way.

I've backed up the ps3 using the 101000 method checked it and it comes up with "The e3 dump is corrupt"

I mean I'm pretty sure that the clip is seated right as I've just put a 10p directly above the clip (kinda like a $0.20) any way

What do you reckon ?

[hellsing9]

You checked your dump and what files are you using to flash your ps3? @abs298