|
|
07-23-2012
|
#1 |
|
Member
 
Join Date: Oct 2011
Location: 0x8C-0x00
Posts: 734
Likes: 228
Liked 340 Times in 222 Posts
Mentioned: 74 Post(s)
Tagged: 0 Thread(s)
|
E3 Flasher, Failed to initialize the bios ( PIC'S ATTACHED )
OLD
/10char Last edited by MJ999; 12-04-2012 at 09:59 AM. |
|
|
|
07-23-2012
|
#2 |
|
Member
 Join Date: Sep 2010
Posts: 232
Likes: 1
Liked 21 Times in 20 Posts
Mentioned: 10 Post(s)
Tagged: 0 Thread(s)
|
Reassemble the upper metal shield back to it's place and put some solid foam over the NOR chip so pressure is created between the MB and the shield . If needed , cut through the shield so the clip can come out
|
|
|
|
|
07-26-2012
|
#3 | |
|
Apprentice
Join Date: Feb 2011
Posts: 2
Likes: 0
Liked 0 Times in 0 Posts
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
|
I didn't understand what do you mean :P if you can show pic's it will be great |
|
|
|
|
|
07-28-2012
|
#4 |
|
Senior Member
 Join Date: Dec 2011
Posts: 4,436
Likes: 965
Liked 1,542 Times in 1,110 Posts
Mentioned: 795 Post(s)
Tagged: 0 Thread(s)
|
Have you shaved some plastic off the clip. Look here.
__________________
HOW TO DOWNGRADE W/E3 FLASHER TO ANY OFW/CFW
Nor model PS3 downgrade service in U.S.A. if you don't want to do it yourself For downgrade help join irc at effnet-Just enter name and channel is #ps3downgrade |
|
|
|
|
08-01-2012
|
#5 |
|
Member
 Join Date: Jan 2008
Posts: 86
Likes: 14
Liked 6 Times in 5 Posts
Mentioned: 3 Post(s)
Tagged: 0 Thread(s)
|
Listen take your pointer finger and middle finger and place them on top of the clip apply a good amount of pressure while trying to very slightly slide the clip left to right so it sets in place after that i used 4 pennies to create the needed pressure. key thing is don't be afraid to use some strength while applying pressure sometime you will hear a click sometimes you wont. you will know its set good when it doesn't wiggle left to right on either side or raise up on either side and it is flush with the board.
|
|
|
|
|
08-01-2012
|
#6 |
|
Senior Member
 
Join Date: Jun 2012
Posts: 1,355
Likes: 245
Liked 421 Times in 301 Posts
Mentioned: 119 Post(s)
Tagged: 0 Thread(s)
|
This is the hardest part. Listen to slaughter, pressure is a good thing in this case. If it isn't completely flush with the board on any side( even a fraction) it won't give you a dump. If it comes off, or lift at all while messing with it, go ahead and make sure you haven't mangled any pins. Also, clean the pins and chip with some isopropyl alcohol. Sometimes there is a slight film on the pins that keeps from good contact. Just use a toothbrush with alcohol. Also, make damn sure you don't do any flashing without multiple good dumps.
|
|
|
|
 |
| Bookmarks |
| Thread Tools | |
|
|
