[leovaras]

Well, many thanks to all those who tried to help me:thumbup: I somehow fixed my own problem. But if you follow my steps, make sure you have a GOOD ERROR FREE backup of your cfw. What i did was set the switches FLASH FUN and OB Flash up, then took a copy of my cfw (bkpps3.bin) and rename it bkpe3.bin. Then pressed START. that way your e3 NOR is re-flashed again in case it gets bricked. After that, turned off the ps3 completely, and pushed up the switch to CFW, switching to the corresponding hdd too.

It turned on just fine on CFW, but this time i updated using E3 CHKOFF TB cfw, since I bricked so many times using TB CFW v2 for some reason. I spend a lot of time, trial and error, but it finally paid off. Now I have dual boot again on my CECHL01 console and have e3 3.55 <==> 4.21 ofw, and no problems whatsoever with True Blue dongle (it turns green) Thanks again guys:thumbup::D
Sent from my LG-MS910 using Tapatalk 2

[racer0018]

Good to hear you got it working. Thanks

[malandrin]

I have a problem, help!!!! I have the model JSD-001 and solder the point A-> SBCE and NOR Tristate-> SBE. But when I turn on my PS3 after 3 seconds turn off, what happens?

[malandrin]

Originally Posted by malandrin I have a problem, help!!!! I have the model JSD-001 and solder the point A-> SBCE and NOR Tristate-> SBE. But when I turn on my PS3 after 3 seconds turn off, what happens?

I can not update the E3, no blue lights. And on the screen says "Can not start, not found adequate system storage" Help!

[playerkp420]

Originally Posted by malandrin I can not update the E3, no blue lights. And on the screen says "Can not start, not found adequate system storage" Help!

The only time my e3 flasher's blue lights did not show up, I had the clip on backwards. Make sure all the connections are good.

[HoOoMaDi]

hi guys i have ps3 fat model CECHJ DIA-002 does i have to do thise or i can switch it normaly OFW & CFW from Eastat

[metroid679]

hii,

i have a e3 flasher limited edition with the tb v2 firmware and have purchased a another hdd 500 gb wd. i would like to use old hdd(tb v2) and the new with 3.55 kamew fw.

is it possible to do it???

if so can u explain how to do it???
************* [ - Post Merged - ] *************
Anyone Please reply....

[HoOoMaDi]

where the blue wire go ?
************* [ - Post Merged - ] *************
the blue wire in the 2nd picture for what?

[HoOoMaDi]

it is soo hard man bi have DIA-002

[dece870717]

If points A and B are not cut, what exactly would happen? I'm trying to figure out why after trying to do dual boot it simply will not allow a bios write to the second part of the dual.