[ZZ008]

console model cech2501a
E3 flasher got the correct dump and on key downgrade successfully.and go into FSM now.
but stoped at the next step: input USB driver console with solied green led and cannot finish install firmware.hdd activiting only a while.
for more information at here:http://e3-forums.com/index.php?topic=10019.0

[ichris]

Originally Posted by ZZ008 console model cech2501a E3 flasher got the correct dump and on key downgrade successfully.and go into FSM now. but stoped at the next step: input USB driver console with solied green led and cannot finish install firmware.hdd activiting only a while. for more information at here:http://e3-forums.com/index.php?topic=10019.0

It has been advised against using Jaicrab.

Read here> http://www.ps3devwiki.com/wiki/Downg...rdware_flasher

[nzie]

Originally Posted by ZZ008 console model cech2501a E3 flasher got the correct dump and on key downgrade successfully.and go into FSM now. but stoped at the next step: input USB driver console with solied green led and cannot finish install firmware.hdd activiting only a while. for more information at here:http://e3-forums.com/index.php?topic=10019.0

Make sure flash drive is fat32 formatted.

[ZZ008]

Originally Posted by ichris It has been advised against using Jaicrab. Read here> http://www.ps3devwiki.com/wiki/Downg...rdware_flasher

thank you for answer.
whats the mean :against using Jaicrab?
i readed this page,but i dont know how to do.
Target_ID is 0B,console has capability of running 3.55.

i format USB driver as FAT16 or FAT32,but as the same problem.
************* [ - Post Merged - ] *************
use normal lv2diag i found UPDATER_LOG.TXT in usb driver.

manufacturing updating start
PackageName = /dev_usb000/PS3UPDAT.PUP
settle polling interval success
vflash is enabled...
creating system regions...
get_device_info() device_id = 0x101000000000007, failure = -2147418110
setup_storage_regions() failure
manufacturing updating FAILURE(0x8002f0e0)
Total Elapsed time = 31587 msec

[nazb2004]

I'm having the same issue. I followed baileyscreams guide and also playerkp420's guide. Both give me the same issue where when i get to the stage to install the cfw with the lv2diag the ps3 shows activity for 10 seconds and just hangs there forever. the updater_log file is empty.

I made 10 dumps and checked them to be all good. flew through the guides without an issue and when i get to installing the firmware it just hangs.

If anyone can help on this I would really appreciate it.

[baileyscream]

bollocks old thread re-opened

Originally Posted by nazb2004 I'm having the same issue. I followed baileyscreams guide and also playerkp420's guide. Both give me the same issue where when i get to the stage to install the cfw with the lv2diag the ps3 shows activity for 10 seconds and just hangs there forever. the updater_log file is empty. I made 10 dumps and checked them to be all good. flew through the guides without an issue and when i get to installing the firmware it just hangs. If anyone can help on this I would really appreciate it.

i say in the main post of my guide that not all usb drives work in fsm

try fully formatting it
then put the files back on it

and next time post in the guide for help


dont open 3 month old dropped threads

i just had to edit a reply i did to the op thinking this was a new ish thread!

[playerkp420]

You guys know you need the hard drive connected, when do the FSM downgrade, right?