|
|
10-05-2012
|
#1 |
|
Member
 
Join Date: Feb 2012
Location: Death's Horizon
Posts: 774
Likes: 251
Liked 196 Times in 150 Posts
Mentioned: 65 Post(s)
Tagged: 0 Thread(s)
|
Proper Heatgun Temps?
Majority of my question is within the title of this thread but its referring to YLOD and GLOD fixes.
__________________
"Ha! Man you're so funny you should be comedian, God Damn! Unfortunately I am I just hide behind the tears of a clown"- Verse from "Beautiful" by 3M1N3M |
|
|
|
10-05-2012
|
#2 | ||
|
Senior Member
 Join Date: Dec 2011
Posts: 4,685
Likes: 1,039
Liked 1,642 Times in 1,180 Posts
Mentioned: 850 Post(s)
Tagged: 0 Thread(s)
|
__________________
HOW TO DOWNGRADE W/E3 FLASHER TO ANY OFW/CFW
Nor model PS3 downgrade service in U.S.A. if you don't want to do it yourself For downgrade help join irc at effnet-Just enter name and channel is #ps3downgrade |
||
|
|
|
|
10-05-2012
|
#3 |
|
Member
Join Date: Feb 2012
Location: Death's Horizon
Posts: 774
Likes: 251
Liked 196 Times in 150 Posts
Mentioned: 65 Post(s)
Tagged: 0 Thread(s)
|
Thanks for the info.
__________________
"Ha! Man you're so funny you should be comedian, God Damn! Unfortunately I am I just hide behind the tears of a clown"- Verse from "Beautiful" by 3M1N3M |
|
|
|
|
10-05-2012
|
#4 |
|
Member
 Join Date: Oct 2010
Posts: 927
Likes: 69
Liked 476 Times in 249 Posts
Mentioned: 51 Post(s)
Tagged: 0 Thread(s)
|
My heatgun has two settings, Low was around 250C and High is around 350C.
I've fix one PS3 and my PC's graphics card serveral times. I start off using Low, just to heat up the board on both sides, stick to Low for a few minutes bringing in the nozzle closer to the chip then moving away. Then I use the High setting for a while, but taking the nozzle further away, but every now and again bring the nozzle close to the chip for like a second then away again, wait a few seconds then back in again. So I do that now and again. Then back to Low to finish it off. Just realise that not all heat guns have the same temp settings, you can can one that does 600C or more, which is too high for electronic boards I believe :P
__________________
 |
|
|
 |
| Bookmarks |
| Thread Tools | |
|
|
