[StriderVM]

The end result is that I can't even go into FSM. It's still supposed to be still in FSM since the last thing I did is flash the original rflash.bin on Jaicrab USB Loader Advance.

It doesn't seem to powerup any USB drive on bootup so no Jig stuff using the USB seems to be no go? It seems to be a soft brick with similarities to the Waninkoko CFW bricks on NAND. Anyway, I'm currently trying to contact some person who might have some knowledge about NAND Writing/Dumping. =/

Here's a video of the brick error message in action. =P

http://youtu.be/zBRXRnXmQcY

Also the Eject sensor in my Fat PS3 is faulty. Crap. So what happens when you put a jig device into the USB, power up the PS3 but don't activate the eject sensor?

[gingerbread]

@StriderVM

Visit this thread. You will find a lot of useful info.

http://www.ps3hax.net/showthread.php?t=40634

[haz367]

@StriderVM , that sucks...i had same error after flashing a cex flash NOR, same thing, also could not enter FSM, what caused it beats me, i had to fix it by hardware flasher also, flashing back the DEX and it boots straight up then re-flashed again using Multiman this time as it only "writes" back the EID section/TargetID and that seems to work alright, each time after trying a couple times, it must be the same for NAND, aka flashing back "full" dump instead can give those weird bricks

[vanpeli]

Originally Posted by itskamel psn was working thru ****psn on dex also before it was patched.

Same here, I played online on DEX, until they patched it ...