[alirza]

I'm sorry I've not the most successful experience with the knowledge that (progskeet) are defined in advance and was working but now stopped.
Is it possible that they may have been disrupted?

[fudd69]

Originally Posted by baileyscream sorry i must have missed your post. what / where do you need help?

************* [ - Post Merged - ] *************

Originally Posted by fudd69 if you find the "trist" or "tristate" point and a "gnd" point on your board (goto ps3devwiki and search for your board ) or go HERE and download the progskeet diagrams and find your board and all the test points are marked up. find the above and solder a wire from gnd to tristate then power up your ps3 and it wont shut off it will just stop booting and "halt" this then lets you re-do the steps from where i said in my prev post.

thanks very much for your help

[baileyscream]

Originally Posted by alirza I'm sorry I've not the most successful experience with the knowledge that (progskeet) are defined in advance and was working but now stopped. Is it possible that they may have been disrupted?

?? i'm sorry but i am really having problems understanding you.

your pc tells you it has detected a usb device when you connect the progskeet so the board is working.
the problem is the driver.
try the steps i listed in the prev reply to you.

btw are you on xp (32x or 64x)
or win 7 (32x or 64x)

[smalltylynch]

Do you just leave the r7 point open or do you put a switch on it?

[Mr.Dutch]

Originally Posted by Frank48888 the title name is awesome!

i heard he spend weeks to come up with that title.

[JustThatDude]

Originally Posted by Mr.Dutch i heard he spend weeks to come up with that title.

10 characters

[Sarah1331]

Me again got your "pack" lol patched my dumped NAND witch all checks out

Trying to flash back I get
Read ... All the addresses
Erase.. All the addresses
Flash... All the addresses
Verify .. Verifacation of the address xxxxx failed on all addresses

I have not touched the wiring since getting the good 8 dumps I took

Please help

I had to change the drop down settings as described in your tut to stop it crashing

[baileyscream]

Originally Posted by Sarah1331 Me again got your "pack" lol patched my dumped NAND witch all checks out Trying to flash back I get Read ... All the addresses Erase.. All the addresses Flash... All the addresses Verify .. Verifacation of the address xxxxx failed on all addresses I have not touched the wiring since getting the good 8 dumps I took Please help I had to change the drop down settings as described in your tut to stop it crashing

just try it again (sometimes it can take a few tries before it says "nothing to flash" ) and report back

[Sarah1331]

I have tried around 6 times it just failed to verify every address but get no errors any other time

Thanks for your response truly grateful

[baileyscream]

Originally Posted by Mr.Dutch i heard he spend weeks to come up with that title.

hmm it was called "ultimate idiots guide to downgrading" but i was asked to change it as it "may" offend lol it was named for me

btw you replied to a bot
************* [ - Post Merged - ] *************

Originally Posted by Sarah1331 I have tried around 6 times it just failed to verify every address but get no errors any other time Thanks for your response truly grateful

try a different usb lead (the shorter the better)

if its still the same then do the following

do a new dump and check its good it.
its a pain i know but i suspect there is a wire dead soldered or has come loose ( i assume you soldered)
if your using a clip then check it is on correct.
************* [ - Post Merged - ] *************

Originally Posted by JustThatDude My title would be***snip****

please check the first post
this is a child friendly thread so no bad language

please edit or remove it please