[dmemedo]

Hello,

Sorry this is my first post, but I've been following this site for at least one year now. But now I've got some question.

I have been waiting for the rebug 4.21 firmware and now that it's out, I decided to install it.

I was on rebug 3.55.2, I installed qa_enabler, but here comes the first problem.

Once I installed the qa_enabler, I did hear the beeps. But since I was on rebug, the "Debug" folder was already there, so I didn't see anything new when I tried the combo buttons.

Is it normal ?

Since I couldn't verify, I installed the enabler many times !

Does installing qa another time disables it or not ?


Then, I decided to try to go to rebug 4.21, which worked.


Now that I'm on 4.21, do you know if there's a way to verify that QA is enabled ?

If I want to go to rebug 3.55.3, do you think I must use the 999 downgrader first or it should work without it ?



Thanks a lot for the great community !

[Hannibal1471]

You don't need qa on 4.21 anymore ... Well you can't use it anyway.
You can use the downgrader pup to downgrade.

[dmemedo]

In REBUG they say when talking about uninstalling 4.21 : "...REBUG 3.55.3 REX EDITION on a QA enabled PS3 or with the ’999′ DOWNGRADER if QA was NOT enabled"

is there any way to verify QA state on 4.21 ?

[Hannibal1471]

You have to install QA on 3.55 and then upgrade to install. So you have qa toggled on 4.2x. That explains it.

[dmemedo]

as I said in my first post :
"Once I installed the qa_enabler, I did hear the beeps. But since I was on rebug, the "Debug" folder was already there, so I didn't see anything new when I tried the combo buttons.

Is it normal ?"

[Ubefuct]

@dmemedo you have to change the xmb in rebug selector to be able to get the added menus for the button combo