[prol4nd]

Hi guys, maybe this will be a noob question, but is it possible to feed the NANDs from external 3,3v, or need to power up the PS3?(progskeet+ps3 phat)

[remusator]

I was thinking about same.

http://www.gme.sk/dokumentace/330/330-167/dsh.330-167.1.pdf

Input up to 24V, output 3,3V.

[prol4nd]

Originally Posted by remusator I was thinking about same. http://www.gme.sk/dokumentace/330/330-167/dsh.330-167.1.pdf Input up to 24V, output 3,3V.

I can confirm It works, Ive used an atx psu. But other problem appears, Winskeet reads only NAND1 even if I click on NAND2 and all wires are soldered. I have tried several bitstream and its the same

[remusator]

So what are you trying to say is, that Progskeet 1.2 is useless with NAND ?

[prol4nd]

Originally Posted by remusator So what are you trying to say is, that Progskeet 1.2 is useless with NAND ?

No, but always changing the clip or soldering between them is not so good.

[remusator]

Considering you are able to solder wires to NAND, you could to this.

Solder wires from progskeet to multiwire connector like this one.
http://www.gme.sk/konektory-pro-ploc...w20g-p800-036/
Solder same connectors on wires going from NAND1 and NAND2.

Make a flat connector cable using piece of flat cable and 2 of these connectors.
http://www.gme.sk/konektory-pro-ploc...fl40-p800-013/

Then you could change from NAND 1 to NAND 2 in seconds, without desoldering. It would be just matter of dis and reconnecting cable ;]

[prol4nd]

Originally Posted by remusator Considering you are able to solder wires to NAND, you could to this. Solder wires from progskeet to multiwire connector like this one. http://www.gme.sk/konektory-pro-ploc...w20g-p800-036/ Solder same connectors on wires going from NAND1 and NAND2. Make a flat connector cable using piece of flat cable and 2 of these connectors. http://www.gme.sk/konektory-pro-ploc...fl40-p800-013/ Then you could change from NAND 1 to NAND 2 in seconds, without desoldering. It would be just matter of dis and reconnecting cable ;]

Yes you are right there is solution for it, but then the pinouts on the progskeet site are false

[bennyoo0]

Okay so I finally have enough money to get this stuff so I wanna know what I need to get so obviously I need Progskeet and an Injectus which I can get here http://www.vgcrepairs.biz/progskeet-...progskeet-v1.2 and a NAND clip which I can get here http://www.vgcrepairs.biz/progskeet-...et-360-tsop-48 I just dont know if I need these wires http://www.vgcrepairs.biz/progskeet-...-pcb-progskeet also i hear the clips are sensitive and pretty much one time use but in the guide the use clamps to hold it in place so could i use it more then once with some clamps?