[Avinitlarge]

Pah, as if. I use this

[Sarah1331]

Originally Posted by Avinitlarge Pah, as if. I use this

How do you fit a 0.5mm bit in that chuck to do the winbonds

[uglbugly]

Originally Posted by stdule How to turn off ps3?try to reflow the cpu because I repaired 3x ps3 slim and I had to do reball cpu then it worked.

I have had a couple fail to start and also found that re-ball cpu has worked.
Not much fun doing the reball on cpu have to mask the centre and still the balls find there way in.

[Avinitlarge]

Originally Posted by Sarah1331 How do you fit a 0.5mm bit in that chuck to do the winbonds

****, that why I keep on killing the boards, I though it was 0.5cm

Originally Posted by uglbugly I have had a couple fail to start and also found that re-ball cpu has worked. Not much fun doing the reball on cpu have to mask the centre and still the balls find there way in.

I might give it a try, Customer is in no rush for it so i'll give it a try next week

[uglbugly]

Originally Posted by Avinitlarge ****, that why I keep on killing the boards, I though it was 0.5cm I might give it a try, Customer is in no rush for it so i'll give it a try next week

Let us know how you get on with it. You will see the problem if using heat direct stencil as the centre of cpu is higher than the outside. Even if just 1 ball gets in there it flows into those components ( 8 legged ones ) and is almost impossible to rectify.

[Avinitlarge]

I only use direct heat on small chips, I hate using them. All my stencils are 90x90