[Panther_X]

I'm going to unbrick this mainboard(with e3 flasher)



(DIA-001 FAT

cechh00 ss)


You can specify a point"PA0" on the image(mainboard)?

tanks

[M8nTrap]

PA0 is A0

on this DIA 001 pics:

http://www.ps3devwiki.com/images/a/a8/DIA-001_NOR.JPG

[Panther_X]

Originally Posted by M8nTrap PA0 is A0 on this DIA 001 pics: http://www.ps3devwiki.com/images/a/a8/DIA-001_NOR.JPG

tank you but No point"PA0"?!or same point"A0"?

and other boards Image Where can I find?

[M8nTrap]

I think your "PAO" is point "AO" , letter "P" means "POINT"...

seeing on the ps3wiki for differents mainboards pinouts.

[redtree]

You can find pin layout here: http://www.ps3devwiki.com/wiki/Hardware_flashing

I think you might mean soldering TRISTATE to keep PS3 on in Flash Fun Mode maybe? If so this is the point on the board for TRISTATE and point on the back of the E3 labelled SBE. With a wire soldered to these points the PS3 will stay on with switch 1 on the E3 Flasher in the up position (Flash Fun Mode).


*E3 Flasher image with SBE label taken from ps3devwiki*

[Panther_X]

Originally Posted by M8nTrap I think your "PAO" is point "AO" , letter "P" means "POINT"... seeing on the ps3wiki for differents mainboards pinouts.

thank you you very much

Originally Posted by redtree You can find pin layout here: http://www.ps3devwiki.com/wiki/Hardware_flashing I think you might mean soldering TRISTATE to keep PS3 on in Flash Fun Mode maybe? If so this is the point on the board for TRISTATE and point on the back of the E3 labelled SBE. With a wire soldered to these points the PS3 will stay on with switch 1 on the E3 Flasher in the up position (Flash Fun Mode). *E3 Flasher image with SBE label taken from ps3devwiki*

thank you you very much