[Sarah1331]

It's for 1.1 and when the sister board for the 1.2 is out it will work on that too or the conversion board


Sent from my iPhone 5 using Tapatalk

[tarizo312]

Originally Posted by tarizo312 I think you may be right. the fan is connected but when I looked at the cpu, it has little to no thermal paste. Could this be the cause of the cut off issue? I do have some paste available. I was waiting til the downgrade and when I put everything back together before doing this.

OK i removed and changed the thermal paste. Now the problem I have is when I turn the PS3 on, It cuts off and I get red blinks. Is it something I did wrong??

[Sarah1331]

Originally Posted by tarizo312 OK i removed and changed the thermal paste. Now the problem I have is when I turn the PS3 on, It cuts off and I get red blinks. Is it something I did wrong??

Can you tell me if this is correct

Does it beep when it goes red light

1.You read your nor and verified it ?
2.you believe you have a soft brick
3.what model??
4.have you flashed your stock back to the console and dumped again and compare your stock verified against the dump to make sure it's got a good stock image on??



Sent from my iPhone 5 using Tapatalk

[Sarah1331]

Sorry for dubble post

[tarizo312]

Originally Posted by Sarah1331 Can you tell me if this is correct Does it beep when it goes red light 1.You read your nor and verified it ? 2.you believe you have a soft brick 3.what model?? 4.have you flashed your stock back to the console and dumped again and compare your stock verified against the dump to make sure it's got a good stock image on?? Sent from my iPhone 5 using Tapatalk

Yes it beeps before I get the blinking red lights.

1. I have read the nor and verified it
2. I do believe I have a soft brick
3. The model is cech-2001a
4. I haven't got to this step yet cause originally it was not reading the HDD connected through esata. I'm using an e3 flasher with nor clip with the hdd connected through a dock.

Thanks in advance for your help.

[Sarah1331]

I would personally write your good dump

Then read it again compare the two if they match you have a good image

Try the console if its the same

Remove everything

Try the console again if its the same patch the dump flash it (read it compare it to the patched so you know you have a good image)

Try the console if it doesn't beep or turns on stick the jig in and fsm it ect

It it still does not work your dump is bad or you have hardware error mate

Hope this helps


Sent from my iPhone 5 using Tapatalk

[tarizo312]

Thanks. I'm working on this now.

[Sarah1331]

Originally Posted by tarizo312 Thanks. I'm working on this now.

Press the thanks then

Press the thanks


Sent from my iPhone 5 using Tapatalk

[tarizo312]

Originally Posted by Sarah1331 Press the thanks then Press the thanks Sent from my iPhone 5 using Tapatalk

Sure if you can tell me how
************* [ - Post Merged - ] *************
Got everything connected and it still beeps 3 times, cuts off and blinking red lights.

[Sarah1331]

Step 1.
write your good dump

Then read it again compare the two if they match you have a good image

Try the console if its the same

Step 2.
Remove everything

Try the console again if its the same

step.3

patch the dump flash it (read it compare it to the patched so you know you have a good image)


Try the console if it doesn't beep or turns on stick the jig in and fsm it ect

It it still does not work your dump is bad or you have hardware error mate



Are you on step 1,2,3?




Sent from my iPhone 5 using Tapatalk