[Muffen]

I know it takes ages and lots of tries to get it to do a dump without 10001100 error, but this time I'm wondering if there is something wrong with the clip? I've sanded it, I've put coin on it, put ducktape on it like a kidnapper and I also tried to hold the clip onto the NOR chip by pressing hard enough with my thumb. Nothing works, It's the same ****.

What to do now, try more? Any ideas how to proceed?

[digiprog]

try cleaning the nor points.. and the clip..

[Mr.Dutch]

Originally Posted by Muffen The famous 10001100

i thought the post was about @Pirate .

[ICECOLDKILLAH]

Originally Posted by Muffen like a kidnapper

firstly i also thought my clip is broken, but then i put a stack of carton under the tape and it worked, i think a coin is not enough

[Muffen]

Originally Posted by digiprog try cleaning the nor points.. and the clip..

I don't have any alcohole to clean it with, just rubbing alcohole, and it contains only 70%, don't know if it's safe.

Originally Posted by ICECOLDKILLAH firstly i also thought my clip is broken, but then i put a stack of carton under the tape and it worked, i think a coin is not enough

I've tried that too. Didn't work. I tried pushing the nor chip down with my thumb serveral times hard as hell while trying to dump, didn't work either...

[ICECOLDKILLAH]

like i said before put a stack of carton under the tape and then put together the metal plates from the mainboard with the screws, its better then pushing it down with your thump, more pressure on the clip, it should work, when not, add some more carton ^^
if this also not works, then it could good be that your clip is broken

[donkey-punch]

Originally Posted by Muffen I don't have any alcohole to clean it with, just rubbing alcohole, and it contains only 70%, don't know if it's safe. I've tried that too. Didn't work. I tried pushing the nor chip down with my thumb serveral times hard as hell while trying to dump, didn't work either...

You need to sand more from the side. Then and only then it will take a valid dump. Just take your time whilst sanding it but make sure to take enough off. Don't be shy ( your mother wasn't )

[Muffen]

Originally Posted by ICECOLDKILLAH like i said before put a stack of carton under the tape and then put together the metal plates from the mainboard with the screws, its better then pushing it down with your thump, more pressure on the clip, it should work, when not, add some more carton ^^ if this also not works, then it could good be that your clip is broken

I've tried 28 times, but I'll try again.

Originally Posted by donkey-punch You need to sand more from the side. Then and only then it will take a valid dump. Just take your time whilst sanding it but make sure to take enough off. Don't be shy ( your mother wasn't )

You're right, she certainly wasn't!

But is this enough sanded, or sand more?

[donkey-punch]

Try and get them corners down some more. They are normally the problem area

[Muffen]

Originally Posted by donkey-punch Try and get them corners down some more. They are normally the problem area

Ok, I've sanded down a lot now, is this fine?