[Sarah1331]

I too have used the patch in baileyscreem guide and not used fsm


Sent from my iPhone 5 using Tapatalk

[katsuru]

Originally Posted by Sarah1331 I too have used the patch in baileyscreem guide and not used fsm Sent from my iPhone 5 using Tapatalk

from 4.31?

[Sarah1331]

Originally Posted by katsuru from 4.31?

No sorry you can only use from 4.3 and lower

Sorry again a total noob like me should think before posting


Sent from my iPhone 5 using Tapatalk

[katsuru]

Originally Posted by Sarah1331 No sorry you can only use from 4.3 and lower Sorry again a total noob like me should think before posting Sent from my iPhone 5 using Tapatalk

I Hope you were being Sarcastic there. You do not yet deserve the noob label work harder for it please!

I was just asking because I am getting confused about the 3M Patch way that Player test and updated on his Tut, if I recall good from 4.31 we always have to go through FSM right ? With either 3M patch or Rogeros patch.

[d2damax]

I have a bigger problem now... I don't think I can turn on my ps3 anymore. My power and eject buttons do not light up anymore and they're both unresponsive. Is there anyway to turn on my ps3? I think I could use the 3M patch but I don't know how I could power my ps3 on again.

I went to a few ps3 repairs services offered around my area. The ones I tried to contact said they could not fix my problem. I honestly don't think I can solder a bypass wire myself. I also tried using a ps3 controller but it did not work.

[Mr.Dutch]

Originally Posted by d2damax I have a bigger problem now... I don't think I can turn on my ps3 anymore. My power and eject buttons do not light up anymore and they're both unresponsive. Is there anyway to turn on my ps3? I think I could use the 3M patch but I don't know how I could power my ps3 on again.

you had the broken prongs right? , can you look at this pic at tell me which prongs are missing? (the numbers)

it sucks that these models need a power/eject board attached to work.

[d2damax]

Originally Posted by Mr.Dutch you had the broken prongs right? , can you look at this pic at tell me which prongs are missing? (the numbers) it sucks that these models need a power/eject board attached to work.

Hey I just opened up my ps3 again and found that only 2, 6, 8, 10 are the only prongs still left attached...

I tried taking a picture but it was too blurry to see anything.

[playerkp420]

Originally Posted by d2damax Hey I just opened up my ps3 again and found that only 2, 6, 8, 10 are the only prongs still left attached... I tried taking a picture but it was too blurry to see anything.

You can downgrade your PS3 without using the eject button.

With METHOD 1 in Chapter 2 of my guide, you can do it without a FSM dongle.

[Mr.Dutch]

Originally Posted by playerkp420 You can downgrade your PS3 without using the eject button.

but some people say this board need to be connected on the 21xx and 25xx else the ps3 won't work at all, although i can't find any proof myself that this is true...

[redtree]

Originally Posted by Mr.Dutch but some people say this board need to be connected on the 21xx and 25xx else the ps3 won't work at all, although i can't find any proof myself that this is true...

I finally got to test the CECH-2503A and can report that with no power/eject board plugged in, inserting a disk caused it to start up. Disk appeared on the XMB and ejected fine by pressing triangle and selecting menu eject option